MOSFET or IGBT in the high side configuration which operates up to volts. Packages. Data Sheet No. PDE. IR HIGH AND LOW SIDE DRIVER. IR datasheet, IR pdf, IR data sheet, datasheet, data sheet, pdf, International Rectifier, High and Low Side Driver, All High Voltage Pins On One. Infineon IRS Gate Drivers are available at Mouser Electronics. Mouser offers inventory, pricing, & datasheets for Infineon IRS Gate Drivers.

Author: Mataxe Gronris
Country: Libya
Language: English (Spanish)
Genre: Technology
Published (Last): 3 January 2012
Pages: 333
PDF File Size: 8.26 Mb
ePub File Size: 2.26 Mb
ISBN: 577-5-36838-302-6
Downloads: 11083
Price: Free* [*Free Regsitration Required]
Uploader: Mokazahn

Log in or register to post comments reads.

Choosing Battery for Robots. Interface SD Card with Arduino. After applying the square waves at Lin and Hin pins, the following voltage waveforms at the Lo and Ho pins were observed on a Cathode Ray Oscilloscope. Make proper connections as loose connections can result into abrupt wave at the output. So, the IR IC under test is working properly.

SPI Module of Arduino. For this, an electrolyte capacitor in parallel with ceramic capacitor for filtering the input power supply can be used.

DC power supply of 5V and 12V. The square wave which has to be applied at the input of Lin and Hin pin is generated by a microcontroller. In the next tutorial learn about improving the switching time of relays. While assembling the circuit for testing the IR IC, following precautions must be taken care of.


Check the input voltage limits from the datasheet of IR If the IC is heating too fast despite not exceeding input supply voltages beyond limit, then also the IC can be predicted to be faulty.

This high-density System-in-Package SiP integrates controller, power switches, and support components. If the exact square wave is not obtained at the LO and HO pins or no square wave is output fromeither pin, then IR in case is faulty.

IR Datasheet(PDF) – International Rectifier

Skip to main content. This gives high output at HO pin. It has the following pin configuration. Virgin Galactic — Commercial Space Flight.

For voltage regulation, the anode of the battery should be connected to pin 1 of the voltage regulator ICs and pin 2 should be grounded.

The IC is having independent low and high side output channel. This should be done to avoid any undermine state at the output. Interface GPS with Arduino. Choosing Motor For Robots.

IR2110S Datasheet PDF

ir2110x A square wave is applied at the Lin and Hin pin with the zero phase difference between them and the wave is generated using a microcontroller. The VDD is the supply voltage for driving the internal circuitry of the IC and it should be in between 3V to 20 V with reference to Vss as per the datasheet. So, high output is obtained at LO pin.


How the circuit works. The IR has the following pin diagram. Since the square wave has to be applied at two pins of the IR, the Arduino is programmed to output square wave from two of its pins. In the internal circuit diagram of IR, the low side and high side blocks are separated with a dotted line for simplicity.

In this tutorial, the method to test the IR IC is discussed. The Arduino is the most popular prototyping board and can be easily programmed to generate a perfect square wave. The IR has the following internal circuitry.

Testing IR2110 Gate Driver IC- ( Part 14/17)

Exclusive Digi-key Tools Embedded computers. By using a single IC, a half bridge circuit can be operated in which one MOSFET is in high side configuration and another one is in the low side configuration.

In the previous tutorial, it was discussed that for driving a MOSFET datadheet high side switch, a gate driver circuit needs to be used.

Related Posts