Systems actually supported. Aritech. Advisor Alarm Panel (CD, CD72, CD34), Master Alarm Panel. (Ats). FP Series Fire Detection Panel (FP Aritech CD Installation manual for control panel Page 3This manual contains installation details for the CD72, CD95 and CD TOPKAPI SCADA software for the control of ARITECH intrusion units CD

Author: Tygoshicage Zoloran
Country: Lithuania
Language: English (Spanish)
Genre: Education
Published (Last): 27 June 2009
Pages: 100
PDF File Size: 5.18 Mb
ePub File Size: 12.64 Mb
ISBN: 689-1-29297-452-9
Downloads: 89358
Price: Free* [*Free Regsitration Required]
Uploader: Zuzuru

If another zone is open, it will be listed and you must again press and the zone number to inhibit it. A split system has two different standby displays. The Programming Cf150 for cd50 various systems can be found at the end of this manual. A summary of the status of the areas appears.

Steps 3 and 4 may be automated by the system. The CD72 can be divided into two independent systems, and the CD95 into eight independent systems. During arming you can exclude zones.


The symbols used to represent the keys are as follows: When you enter your code, the system disarms, the bells and the flashing light are switched off, and the central station receives the report that the alarm has been deactivated.

Use the 0 dc150 to cancel an incorrect entry and to restart a new entry of the code. The alarm is being set. The area is disarmed.


For information about excluding open zones, refer to the section Arming a system which has open zones on page 8. AU Australia s largest More information. Area 1 Disarmed Area 2 Disarmed 6. Change Codes Change own code s if programmed other codes and user names 8. These instructions also apply to users who only have access to a single alarm system in the premises, although aritwch systems may actually be present.

An example is shown. These instructions apply to both the CD95 and CD If programmed, the buzzer for the area will begin. The bells, keypad buzzers and flashing light may also be active. Operator Log Detailed list of activation and system operations. Arm Menu There are four sub-options, each allowing you to carry out a different operation: Leave the secured area now. Special keys The following key combinations can be programmed by the installer. The entire manual should be carefully. Systems which are armed or have been triggered cannot be selected.


Aritech Fire Panel Boards Documents. You must then check that the doors, windows, etc. Published on Dec View Download 2. In this example you should enter your code and then press the Accept key. Separate alarm and tamper connection The other options are cs150 under Special keys.

When you are in an option list, this key can be used to go backwards in the list. AU Australia More information. As long as this beeping continues, you can disarm switch off the system with xd150 code without activating an alarm.


Is there a flashing More information. The area is being armed the exit time is still operating. Enter the area number in this example it is 1. You also must not enter other areas of the system during the beeping.

ADVISOR CD 7203 CD95/15003

When properly maintained, the system will provide years of reliable operation. A split system lets you control open zones in specific areas of the premises. Inside Front Glossary of Terms The buzzer begins to beep. Please contact your alarm installer if you require. Ccd150 alarm and tamper connectionDual loop: Please read these instructions carefully.

ARITECH Supervision

Further SLC BV reserve the c150 to revise this publication and to make changes from time to time in the contents hereof without the obligation of SLC BV to notify any person of any such revision. How to unset system in alarm.

If your code lets you access more than one security area, you can select one of them to arm. A system that has more than one security area it is called a split system.

Related Posts